Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.įEDERAL COMMUNICATIONS COMMISSION (FCC) PART 15 STATEMENTS Recommendations must be included for a specific program of frequent testing (at least weekly) to insure the system's operation at all times.įCC STATEMENT This device complies with Part 15 of the FCC Rules and RSS210 of Industry Canada. The installer should assume the responsibility of developing and offering a regular maintenance program to the user, as well as acquainting the user with the proper operation and limitations of the alarm system and its component parts. Regular maintenance and inspection (at least annually) by the installer and frequent testing by the user are vital to continuous satisfactory operation of any alarm system. NOTE: Use care not to bend the antenna while attempting to remove or install the battery. Remove the two screws securing the cover and two mounting screws as shown in figure 1. Exercise caution not to jar the case while replacing the battery, possibly breaking the Tamper breakaway tab. IMPORTANT: When servicing the device for battery replacement, note that with the mounting screws removed the case is held in place by the tamper release tab. Dispose of used batteries promptly and properly. Do not recharge, disassemble, heat above 100☌, or incinerate. Typical Holdup Switch InstallationīATTERY CAUTION: Risk of fire, explosion, and burns. Supplied, Part Number K4563 to order separatelyįigure 3. 6x1/2 IMPORTANT: THIS DEVICE MUST BE PERMANENTLY MOUNTED WITH THE SCREWS SUPPLIED. ADEMCO 466, Duracell DL123A, Panasonic CR123A, Varta CR123A.ĬOVER SCREW (2) No. Reinstall two cover screws and two mounting screws as shown in Figure 1. Observing correct polarity (negative side of the battery facing the trigger), insert the battery into the battery holder as shown in Figure 1. Remove faulty battery and dispose of properly. NOTE: THE NEGATIVE ( - ) SIDE OF THE BATTERY MUST FACE THE TRIGGER Secure the case with the cover to its mounting location using the two screws (No. IMPORTANT: To prevent damage to the case, do not over tighten the cover screws. Secure the cover to the case with the two screws (No 6 x 1/2) as shown in Figure 3. 6 x ¾ screw (supplied) at the breakaway tamper release hole as shown in Figure 3. Position the case to the desired location and install one No. Install the battery into the battery holder observing correct polarity as shown in Figure 2. Before mounting the 5869 permanently, perform Go/No Go tests to verify adequate transmitter signal strength at desired mounting location (refer to the Security System Control Panel Installation and Setup Guide). Refer to the figure and steps that follow for typical mounting installation. Mount the 5869 under a counter or money drawer for easy access by the cashier.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |